資料介紹:
A - 1
[DESIGN PRECAUTION]
DANGER
Do not write data into the "system area" of the buffer memory of intelligent function modules.
Also, do not use any "prohibited to use" signals as an output signal to an intelligent function
module from the programmable controller CPU.
Writing data into the "system area" or outputting a signal for "prohibited to use" may cause a
malfunction of the programmable controller system.
CAUTION
Do not bunch the control wires or communication cables with the main circuit or power wires, or
install them close to each other.
They should be installed 100mm(3.9inch) or more from each other.
Not doing so could result in noise that may cause malfunction.
At power ON/OFF, voltage or current may instantaneously be output from the output terminal of
this module. In such case, wait until the analog output becomes stable to start controlling the
external device.
編碼器接頭 MR-J3ENSCBL20M-H
SSCNET Ⅲ 光纖 MR-J3BUS20M-A
輸入輸出模塊 FX2N-8ER-ES/UL
伺服電機 HC-MFS053B
模塊 AJ71J92-S3
電磁制動器用電纜 MR-BKS1CBL2M-A1-L
CPU單元 A1SJCPU-S3
擴展電源單元 FX3U-1PSU-5V
串行通信單元 GT15-RS4-9S
定位控制模塊 A1SD75P3-S3
伺服電機 HC-SFS353B
伺服電機 HC-SFS102B
PLC FX1S-20MR-001
伺服馬達 HA-LFS701M
保護膜 GT10-30PSGW
伺服馬達 HC-RFS103K
伺服電機 HC-KFS23B
伺服電機電源用電纜 MR-PWS2CBL03M-A1-L
SSCNET Ⅲ 光纖 MR-J3BUS015M
Ethernet模塊 A1SJ71E71N-B5
PLC FX3U-16MT/DS
GOT到GOT長距離連接電纜 GT15-C100BS
伺服放大器 MR-J2S-100A
PLC FX3U-16MT/DSS
As-i模塊 QJ71AS92
保護膜 GT15-60PSCB
可控硅輸出模塊
AJ35PTF-24S
擴展電纜 A1SC07NB
輸入模塊 AJ65SBTB1-8D
伺服放大器 MR-J2S-70B