精品国产一区二区-精品国产一区二区三区19-精品国产一区二区三区www-精品国产一区二区三区不卡-精品国产一区二区三区不卡在线

1. To prevent electric shock, note the following
WARNING
Before wiring or inspection, turn off the power and wait for 15 minutes or more until the charge lamp turns
off. Then, confirm that the voltage between P( ) and N( ) is safe with a voltage tester and others.
Otherwise, an electric shock may occur. In addition, always confirm from the front of the servo amplifier,
whether the charge lamp is off or not.
Connect the servo amplifier and linear servo motor to ground.
Any person who is involved in wiring and inspection should be fully competent to do the work.
Do not attempt to wire the servo amplifier and linear servo motor until they have been installed. Otherwise,
you may get an electric shock.
Operate the switches with dry hand to prevent an electric shock.
The cables should not be damaged, stressed, loaded, or pinched. Otherwise, you may get an electric shock.
During power-on or operation, do not open the front cover of the servo amplifier. You may get an electric
shock.
Do not operate the servo amplifier with the front cover removed. High-voltage terminals and charging area
are exposed and you may get an electric shock.
Except for wiring or periodic inspection, do not remove the front cover even of the servo amplifier if the
power is off. The servo amplifier is charged and you may get an electric shock.

2. To prevent fire, note the following
CAUTION
Install the servo amplifier, servo motor and regenerative resistor on incombustible material. Installing them
伺服馬達 HA-LFS6014
背光燈 GT15-90XLTT
編碼器接頭 MR-J3ENCBL5M-A1-H
RS-485端子臺轉換電纜 FA-LTBGTR4CBL20
存儲器盒 FX3U-FLROM-64
GT15人機界面 GT1550-QLBD
交流電抗器 FR-HAL-H185K
伺服馬達 HA-LFS801
編碼器電纜 MR-JHSCBL2M-L
伺服馬達 HA-LFS701M
PLC FX2NC-96MT-D/UL
PLC FX1N-40MT-ES/UL
電磁制動器用電纜 MR-BKS2CBL03M-A2-L
大型擴展基板 Q55BL
Melsecnet模塊 A1SJ71LP21
GT10觸摸屏 GT1020-LBD
編碼器接頭 MR-J3ENCBL10M-A2-H
直流電抗器 FR-HEL-H15K
GT10觸摸屏 GT1020-LWL
GT11觸摸屏 GT1150-QLBD
SI/QSI光纜型模塊 QJ72LP25-25
直流電抗器 FR-HEL-H18.5K
交流電抗器 FR-HAL-H37K
伺服電機電源用電纜 MR-PWS1CBL10M-A2-L
伺服電機電源用電纜 MR-PWS1CBL10M-A1-L
編碼器電纜 MR-JCCBL20M-H
編碼器接頭 MR-J3ENCBL5M-A2-L
總線連接單元 GT15-75ABUS2L
MELSEC-I/O LINK主站模塊 FX2N-16LNK-M
伺服馬達 HA-LFS11K24B