精品国产一区二区-精品国产一区二区三区19-精品国产一区二区三区www-精品国产一区二区三区不卡-精品国产一区二区三区不卡在线

(1) Do not drop the module or cause it to receive strong impact.
(2) Do not remove the PCB of the module from its case.
Doing so may cause the module to fail.
(3) Always make sure to touch the grounded metal to discharge the
electricity charged in the body, etc., before touching the module.
Failure to do so may cause a failure or malfunctions of the module.
(4) Tighten the screws to the specified torque shown below.
Insufficient tightening torque could result in shorts, failures or
malfunction.
4.1 Mounting module fixing bracket
Hold the Q66DA-G with module fixing bracket after the Q66DA-G is
mounted to the base unit.
Screw location Tightening torque range
Module mounting screw (M3 screw) 0.36 to 0.48 N•m
FG terminal screw (M3 screw) 0.42 to 0.58 N•m
POINT
Make sure that the module fixing bracket is hooked on the 3rd slit
模塊 AJ35PTC-CNV-GI
模塊 AJ35PP-CNV-GI
AS-I主站模塊 FX2N-32ASI-M
轉(zhuǎn)換適配器 FX2NC-CNV-IF
外部輸入/輸出單元 GT15-DIOR
CCLink模塊 AJ65BT-64DAI
模擬量輸出模塊 A68DAI-S1
中繼模塊 AJ65BT-RPI-10A
模塊 AJ35PTC-CNV-SI
模擬量模塊 AJ65VBTCU-68ADIN
模塊 AJ71ID1-R4
模塊 AD35ID2
仿真單元 A6SIM-X64Y64
適配器 Q6DIN1
ID接口模塊 QD35ID1
速中斷模塊 A1SI61
中斷模塊 AI61-S1
中繼模塊 AJ65BT-RPI-10B
模塊 AJ71ID2-R4
模塊 A1SJ71ID2-R4
模塊 AD35ID1
適配器 Q6DIN3
模塊 AJ35PTC-CNV-SI
轉(zhuǎn)換電纜 FX2N-CNV-IF
模塊 A1SD32ID1
模塊 A1SD35ID2
模塊 A1SJ71ID1-R4
模塊 AD32ID1
RS-232C通訊用模塊 FX2N-232IF
適配器 Q6DIN1A